Glow & Go Full Nail Kit

Step 1 — Protect 🛡️
Apply the Peel-Off Base Coat over your natural nail. It forms a flexible film — a barrier between your nail and everything else. Air-dries in 60 seconds.

Step 2 — Bond 💅
Apply UV Solid Tip Gel over the film and press your nail tip into place. The gel bonds to the film — not your natural nail. Your nail is protected underneath.

Step 3 — Cure ⚡
Cure under the included UV/LED lamp for 60 seconds. Salon-grade hold. Waterproof, flexible, survives dishes, the gym and real life.

Step 4 — Peel 🫧
When you're ready to change — peel the base coat off with one finger. 30 seconds. No acetone. No tools.
No damage. Your natural nail is exactly as you left it.

Every other nail system bonds directly to your nail plate. When it comes off, it takes a layer of your nail with it. That's not a side effect — it's how every existing system is built.

Glow & Go applies a base coat film first. The gel bonds to the film, not your nail. Your nail is never touched. So removal can never damage what was never contacted.

The UV gel cures to salon-grade bond strength. Waterproof, flexible, built for real life. Most customers wear one set for 1–2 weeks with zero lifting.

But because removal is damage-free, you can change them every day if you want. That's the point.

Apply a small amount of Gel Remover around the edge of the nail. Then peel from one corner with your finger. The entire set comes off in one piece in about 30 seconds.

No soaking. No filing. No acetone. Your nail is exactly as you left it.

Each set includes 15+ sizes. Hold the tip against your nail — it should cover the full width without touching the skin on either side. Between sizes, go smaller.

After curing you can file and shape the tip. So you're never locked into the factory size.

Yes. The UV gel cures to a fully waterproof bond — the same technology professional nail techs use. Dishes, gym, typing, cooking. No problem.

The gel flexes with your nail instead of cracking. Built for real life, not just photos.