How To Use

Glow & Go

How To Use

Apply in 10 minutes  ·  Peel off in 30 seconds  ·  Zero damage

Step 1–3 · Prep

  • 1

    Wash hands & dry completely 1 min

    No oils, no lotion. Clean, dry nails = maximum hold. Skip this and the tips won’t last.

  • 2

    Size your nail tips

    Match each tip to your natural nail width. Use the included sizing guide — 15+ sizes per set. File the tip edges if needed for a perfect fit.

  • 3

    Lightly buff the nail surface 30 sec

    One light pass with the buffer — just enough to remove shine. This helps the base coat grip evenly.

Application

Step 4–7 · Apply

  • 4

    Apply Peel-Off Base Coat to all nails ★ Key Step

    Thin, even layer. Cover the entire nail surface — edge to edge. Do NOT get it on your skin. This is your nail’s protective shield.

    Peel-Off Base Coat · air dries in 60 sec — no lamp needed

  • 5

    Wait for base coat to fully dry 60 sec

    It should look matte and slightly shrunken. If it still looks wet — wait longer. Do not rush this step.

  • 6

    Apply Solid Tip Gel inside the nail tip ★ Key Step

    Scoop a small amount (pea-sized) from the jar. Warm it between your fingers for 5 seconds to soften. Press flat inside the tip. Less is more — too much gel causes air bubbles and lifting.

    Solid Tip Gel (HEMA FREE) · UV/LED cured

  • 7

    Press tip onto nail & cure under lamp 60 sec

    Press firmly from cuticle down. Hold flat and still for 10 seconds. Cure all nails under the UV/LED lamp for 60 seconds. Do not move or touch during cure.

    Mini UV/LED Lamp · included in bundle

Finish

Step 8 · Optional finish

  • 8

    File & shape the tips

    Once cured, file to your preferred shape — square, almond, oval. The gel holds the tip firm so you can shape freely without cracking.

⌛ Total application time ~10 minutes
Removal · zero damage

Step R1–R3 · Remove when ready

  • R1

    Apply Nail Glue Remover around the edge 10 sec

    Use the pinpoint applicator. A tiny drop along the side edge of the tip is enough — this loosens the seal between the tip and the base coat film.

    Nail Glue Remover · acetone-free · enriched with Vitamin E

  • R2

    Peel off the base coat in one piece ★ The Moment

    Slide a cuticle stick under the edge. Peel the entire base coat film sideways — gel tip comes with it. One piece. 30 seconds. Your natural nail is completely untouched underneath.

  • R3

    Moisturize with cuticle oil 1 min

    Massage cuticle oil into each nail. Your nails were protected the whole time — this keeps them hydrated and healthy for the next set.

⌛ Total removal time ~2 minutes

⚠️ Nails must be dry

Oils and moisture break the base coat seal before it even starts. This is the #1 reason tips fall off early.

☀️ Full 60 sec cure

Under-cured gel is the #1 reason tips pop off in 24 hours. Don’t rush the lamp step.

💧 Less gel = better bond

Too much Solid Tip Gel causes air bubbles and lifting at the edges. Pea-sized is enough.

↔️ Peel sideways, not up

Roll the film sideways — it comes off cleanly in one satisfying piece. Pulling straight up tears the film.

🛡️ No acetone. No filing. No damage. Your natural nail never touched the gel — so removal can never hurt it. That’s the Glow & Go difference.